Open Access
Investigation of ASTM F75 Co-Cr-Mo alloy's abrasive wear behavior
Arsalan Alamdari Ilkhchi1*, Mahmut İzciler2
1Gazi Üniversitesi, Teknoloji Fakültesi, İmalat Mühendisliği  , Ankara, Turkey
2Gazi Üniversitesi, Teknoloji Fakültesi, İmalat Mühendisliği  , Ankara, Turkey
* Corresponding author: arsalan.alamdari@gmail.com

Presented at the Ist International Symposium on Innovative Approaches in Scientific Studies (ISAS 2018), Kemer-Antalya, Turkey, Apr 11, 2018

SETSCI Conference Proceedings, 2018, 2, Page (s): 190-190 , https://doi.org/

Published Date: 23 June 2018    | 666     11

Abstract

In this study, abrasive wear behaviors of Co-Cr-Mo alloy (ASTM F75) which is produced by casting method, were investigated. The prepared test samples were subjected to abrasive wear tests with different emery papers on the pin on disc wear device. In the abrasive tests, 400, 600 and 800 mesh emery papers were used and abrasive wear tests were performed under loads of 5, 10 and20 N. The tests were carried out at 22 oC temperature, at a shear rate of 0.8 m / s and at a length of100 cm shear distance. EDS elemental analysis was performed to investigate the elements andchemical constituents on the surfaces of the samples and EFM surface analysis was performed toexamine the qualities and roughness of the surfaces. The obtained results showed less weight loss at the higher meshes. It was observed that better quality surfaces were found in tests which were performed in higher mesh sizes.

Keywords - ASTM F75 Co-Cr-Mo, Abrasive Wear, Surface Roughness, Pin on Disc

References

SETSCI 2024
info@set-science.com
Copyright © 2024 SETECH
Tokat Technology Development Zone Gaziosmanpaşa University Taşlıçiftlik Campus, 60240 TOKAT-TÜRKİYE